Demolished when the Frisbee！ The brake disc of old age a new one?
In general， the brake racingreplacement of two sets of pads， brake disc life should be to the end of (depending on the original specification， usually wear range is about 2mm or so)， the thin disc will increase the brake fluid the temperature more easily in the stampede of brake issued a different tone and even shorten the life of the brake system， and may even cause the brake when the steering wheel jitter phenomenon。 Therefore， timely replacement of the brake disc to really contribute to traffic safety to mention N。

Production details

Materials needed: one pair of brake disc (2) about 1500 ~ 2000 yuan

Sandpaper 10

Tools: Phillips screwdriver

A slotted screwdriver

14-17mm glasses wrench

10mm plum open wrench

Hammer

Elastic

No。 100 sandpaper a

Tire removal tool

Time required: 40 minutes

Construction difficulty: ★ ★ ★ ☆ ☆

Removable tire， you can see the disc brake assembly。

The dish was two screws above Kazakh help， you can use the impact driver or the way the figure， edge knock the edge to loosen the screw。

Calipers and bracket screws to the CR-V models， for example， 14mm and 17mm。 As long as the use of simple glasses wrench will be able to remove the three screws。

First rotating the 14mm screws， opened calipers， take out the pads。

And then spin out the two 17mm caliper mounting screws， you are ready removal of disc calipers removed the elastic band will be hanging above the shock absorbers must not use the brake tubing it hanging in the air。