Sliding bearings with grease lubrication cycle
Occasional work, slide bearing the unimportant parts: shaft speed <200r/min, five days of the lubrication cycle time; shaft speed> 200r/min, lubrication cycle every three days. Intermittent work: shaft speed <200r/min, two days of the lubrication cycle time; shaft speed> 200r/min, Plastic bearing lubrication cycle days. Continuous work, the operating temperature less than 40 ° C: shaft speed <200r/min, one day of the lubrication cycle time; shaft speed> 200r/min, the lubrication cycle once per shift. Continuous work, the working temperature of 40-100 ° C: shaft speed <200r/min, the lubrication cycle once per shift; shaft speed> 200r/min lubrication intervals in each class secondary.
Edit this paragraph Scraping technical requirements
Plain bearings
The basic requirements
Both to make contact, journal and sliding bearing uniform fine as well as with the gap.
Contact angle
Refers to the journal and the contact surface of the sliding bearing on the central angle. Contact angle can not be too large nor too small. Pressure to increase the contact angle is too small to make plain bearings, in severe cases make plain bearings have a greater deformation, accelerated wear and shorten life; contact angle is too large, it will affect the film formation, not a good liquid lubrication. Experimental studies have shown that the limit of the sliding bearing contact angle is 120 °. When the sliding bearing wear to this contact angle, liquid lubrication is necessary to destroy. Therefore do not affect sliding bearing pressure conditions, the contact angle as small as possible.
Theoretical analysis, distance from the friction when the contact angle of 60 °, the smallest friction torque, so the recommended speed is higher than the 500r/min The sliding bearings, contact angle 60 °, speed below 500r/min the sliding bearing, The contact angle of 90 °, 60 ° can also be used.
Point of contact
Journal sliding bearing surface of the contact situation, the actual contact points per unit area. Point of contact the more the more detailed, more uniform, indicating that the sliding bearing scraping the better, and vice versa, said sliding bearing scraping bad. Generally speaking, the finer points of contact and the more, scraping the greater difficulty.
|
